Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to CLEANING CAVITIES DURING VIBE TUM BLING PROCESS from tony goffe on July 06, 2014 at 20:53:08:

Re: CLEANING CAVITIES DURING VIBE TUM BLING PROCESS

Hi Tony,

I've been using a high pressure silkscreen cleaning gun for many years to clean grit, polish and dirt from fractures and cavities on spheres, agates and crystals.

These cleaning guns are not that expensive and do a great job in getting into hard to reach cavities.

One thing you need to keep in mind is this is a High Pressure water gun. You need to keep your fingers away from the nozzle and spray from the gun. It can inject water into your skin and it hurts when it does.

Check out the web site below.

http://www.ebay.com/itm/Screen-Printing-Spot-Cleaning-Gun-110-volt-MYSTIC-NIB-/190925038612?pt=LH_DefaultDomain_0&hash=item2c7404e414

Rich

From Rich Sink - July 07, 2014 at 10:38:36
Email:

Message: 70931



Message Reply Form

Use the form below to post a reply to the Re: CLEANING CAVITIES DURING VIBE TUM BLING PROCESS message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.

Your Name: (Required)
E-Mail Address: (Optional)
Subject: Re: Re: CLEANING CAVITIES DURING VIBE TUM BLING PROCESS
Reply Message: (Required)
Last chance to check your message for typos!

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Bob Keller