Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

changing the roller on a Durston Rolling Mill

I was wondering has anyone out there had experience with changing the roller on a Durston 100mm Rolling Mill? If so how much is involved in doing so. I�m looking at a Durston 100mm Electric Single Rolling Mill, but I need to remove one the flat rollers and have two large �D� groves (8x6mm) machined into it.

From Bob Place - November 14, 2013 at 01:48:41
Email:

Message: 70834



Message Reply Form

Use the form below to post a reply to the changing the roller on a Durston Rolling Mill message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.

Your Name: (Required)
E-Mail Address: (Optional)
Subject: Re: changing the roller on a Durston Rolling Mill
Reply Message: (Required)
Last chance to check your message for typos!

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

 
Visit Our Online Store For Faceters!
Ultralaps & Lap Containers   Dopping Supplies   Faceting Accessories & Displays   Loupes & Optivisors   Polishes   Saw Blades & Coolants   Cobbing Kit   Dichroscopes   Faceting Books, CDs & Videos   Check Out Our Closeouts & Specials  

Bob Keller