Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to changing bearings lortone combination unit from carl shearer on November 03, 2012 at 23:41:35:

Re: changing bearings lortone combination unit

The bearings might be press on. take the shaft a shop and have them press off. Using a pipe and hammer can damage a bearing. I have been a macinest for over 25 years and this the only right way to do this.

From Edward Perrin - November 08, 2012 at 03:28:35
Email:

Message: 70526



Message Reply Form

Use the form below to post a reply to the Re: changing bearings lortone combination unit message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.

Your Name: (Required)
E-Mail Address: (Optional)
Subject: Re: Re: changing bearings lortone combination unit
Reply Message: (Required)
Last chance to check your message for typos!

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Bob Keller