Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to Re: Re: Re: Newbie question about saw lubricants from Ward on October 14, 2012 at 23:49:55:

Re: Re: Re: Re: Newbie question about saw lubricants

RE: Lubricating oil for slab saws.
I have been using Industrial oil 70, a Conoco product. It is a little heavier than
Texaco's Almag but much cheaper. About $10/gallon here in Northern Montana. IT works fine, but I clean the saws more often because it does not settle out as good. This mineral oil is used by contractors to spray wood concrete forms.

From Larry Ochsner - November 01, 2012 at 00:48:36
Email:

Message: 70517



Message Reply Form

Use the form below to post a reply to the Re: Re: Re: Re: Newbie question about saw lubricants message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.

Your Name: (Required)
E-Mail Address: (Optional)
Subject: Re: Re: Re: Re: Re: Newbie question about saw lubricants
Reply Message: (Required)
Last chance to check your message for typos!

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Bob Keller