Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to Newbie question about a Si Carbide Wheel X 2 from dirk on October 06, 2012 at 22:02:52:

Re: Newbie question about a Si Carbide Wheel X 2

When I was a kid all my units were silicone. I used to spend hours--literally--making 30x40 cabs out of agate. And I loved every minute of it lol.

No patience for that now! A good supplier for wheels is kingsleynorth.com. While im sure everyone will say get sintered wheels they are ultra expensive and you can get running with the kingsley brand wheels for a lot less upfront. They won't last as long but most people can't drop that kind of $.

In regards to the original question I would replace them, no questions asked. It's kinda like this: if you don't they will fly apart. If you do then they were ok in the first place. Don't ask me why it just works that way lol.

From Rdnoble - October 09, 2012 at 23:38:01

Message: 70480



Message Reply Form

Use the form below to post a reply to the Re: Newbie question about a Si Carbide Wheel X 2 message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.

Your Name: (Required)
E-Mail Address: (Optional)
Subject: Re: Re: Newbie question about a Si Carbide Wheel X 2
Reply Message: (Required)
Last chance to check your message for typos!

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Bob Keller