Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

B & I Gem Maker

I've got a 10 inch B & I unit sold by Sears under the Craftsman name. Used it off and on for over 50 years and still use it. The bearings seem to need replacing. How hard is this to do and where would I get the replacement parts?

Thought about getting a replacement unit, maybe an 8 inch Inland unit, and limiting my use of it to just sawing. Any thoughts?

From Buz - June 29, 2012 at 22:45:11
Email:

Message: 70391



Message Reply Form

Use the form below to post a reply to the B & I Gem Maker message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.

Your Name: (Required)
E-Mail Address: (Optional)
Subject: Re: B & I Gem Maker
Reply Message: (Required)
Last chance to check your message for typos!

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Bob Keller