Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to Water Hydraulic Slab Saw from Jim on September 28, 2010 at 17:57:43:

Re: Water Hydraulic Slab Saw

Jim I am not familiar with your saw. Assuming that no one familiar with your saw contacts you, I would install a pressure valve if you don't already have one on your saw and contact Diamond Pacific to find out what pressure they operate their 18 inch hydraulic saw and what is the size of their hydraulic cylinder. Diamond Pacific manufactures a whole line of oil hydraulic saws. You may have to do some calculating to factor the information from Diamond Pacific to fit your saw. There should be no difference between pressure applied by either water or oil.

From jay bates - September 30, 2010 at 19:13:14

Message: 69411



Message Reply Form

Use the form below to post a reply to the Re: Water Hydraulic Slab Saw message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.

Your Name: (Required)
E-Mail Address: (Optional)
Subject: Re: Re: Water Hydraulic Slab Saw
Reply Message: (Required)
Last chance to check your message for typos!

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Browse Our Online Gallery of Wilensky Quality Minerals - Order Our Video Catalog!

Bob Keller