Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to Working with deer and elk antlers from Mary Madrid on August 22, 2010 at 20:22:46:

Re: Working with deer and elk antlers

I made buttons from deer antler some years ago. As far as I can remember, I cut them with a Dremel jigsaw (this was before I owned any rock-working saws). I cut them about 3/16 inch thick and drilled two holes for the thread. Don't rmember doing anythng else to them, and they have held up well over the years, husband is still wearing the wool shirt. (Was washable wool, and so buttons have gone through many washngs over th years.)

Becky

From Becky Kelher - August 24, 2010 at 17:28:52
Email:

Message: 69331



Message Reply Form

Use the form below to post a reply to the Re: Working with deer and elk antlers message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.

Your Name: (Required)
E-Mail Address: (Optional)
Subject: Re: Re: Working with deer and elk antlers
Reply Message: (Required)
Last chance to check your message for typos!

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop


Bob Keller