Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to Re: Re: higland park E10 restartup procedure? from Tom Knoch on July 02, 2010 at 21:54:21:

Re: Re: Re: higland park E10 restartup procedure?

I use 7" blades I've ordered from the internet, I don' remember which vendor but there are a number of good ones. 9" blades are a little too close to the edges for me. I use mine mostly as a trim saw. I have cut rough as big as 4", but you have to cut halfway then turn it over and cut thru the other half.

From Tim Casey - July 03, 2010 at 13:51:52

Message: 69178



Message Reply Form

Use the form below to post a reply to the Re: Re: Re: higland park E10 restartup procedure? message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.

Your Name: (Required)
E-Mail Address: (Optional)
Subject: Re: Re: Re: Re: higland park E10 restartup procedure?
Reply Message: (Required)
Last chance to check your message for typos!

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Bob Keller