| Message Index | Start New Topic | Photo Gallery | FAQ and Use Tips | Bob's Rock Shop |
Posted in response to Cutting fluid for grinders? from TC Reg on November 09, 2009 at 11:04:12:
|
I have been reading the replies with interest, because I am sure I saw as ad a few months ago touting a slab/trim saw that used water. Thought at the time, wow, that would be great! This post revived my interest, and I went looking. You know how that goes, right? But, did come across a further explanation for the oil argument on the Lortone site. They claim that the oil is not only for cooling, but for lubricating the screw-drive mechanism. So apparently the lubrication part does not have to do with the blade-rock interface, but rather with the screw drive. If I do manage to come across the info I've supposedly seen on the water cooled one, will post it. Becky
From Becky Kelher - November 12, 2009 at 04:25:37
|
Message Reply Form
Use the form below to post a reply to the Re: Cutting fluid for grinders? message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.
| Message Index | Start New Topic | Photo Gallery | FAQ and Use Tips | Bob's Rock Shop |
