Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to Re: I.D. metal dop pins for a faceting machine from Ward on October 09, 2009 at 09:30:42:

Re: Re: I.D. metal dop pins for a faceting machine

Thanks for the info, Ward...my dops don't have any pins...just the groove machined into the end...are yours 2 5/16" long?

From rockhead - October 10, 2009 at 11:14:47
Email: folgers100[ ]yahoo.com

Message: 68413


Message Reply Form

Use the form below to post a reply to the Re: Re: I.D. metal dop pins for a faceting machine message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.

Your Name: (Required)
E-Mail Address: (Optional)
Subject:Re: Re: Re: I.D. metal dop pins for a faceting machine
Reply Message: (Required)
Last chance to check your message for typos!

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

   Buyer's Guide Books   Collecting Guide Books    Crystal and Gemstone Healing   Faceting Books & Videos   Faceting Machine Manuals    Fossil Books   Gemstone Books    Gold Prospecting and Mining History Books   Jewelry Making Books & Videos    Lapidary Books & Videos   Mineral Books   Mineralogical Record Back Issues    Stone Setting Books & Videos    Used & Out-of-Print Books  

Bob Keller