| Message Index | Start New Topic | Photo Gallery | FAQ and Use Tips | Bob's Rock Shop |
Posted in response to I.D. metal dop pins for a faceting machine from rockhead on October 08, 2009 at 09:24:29:
|
Rockhead, was wondering if there is a little pin sticking out the side of the dops? It is an allignment pin for the chuck.
From Ward - October 09, 2009 at 09:30:44
|
Message Reply Form
Use the form below to post a reply to the Re: I.D. metal dop pins for a faceting machine message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.
| Message Index | Start New Topic | Photo Gallery | FAQ and Use Tips | Bob's Rock Shop |
 |
 |