Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to Re: Re: Cutting Agate with a Chicago Electric Tile Saw? from Mike C on June 13, 2009 at 12:55:41:

Re: Re: Re: Cutting Agate with a Chicago Electric Tile Saw?

whats the RPM`s on the motor? mine is 3450 on a 10 inch highland park saw, I needed it to get down to 1200-1700 range so I put a bigger pulley on the blade, motor pulley was 1/12 and the blade was 3 inch, now its 4 1/2 and I now have a cutting speed of around 1550, I use water and a drop of dish soap, I cut mainly coral and some agates

From jeff capron - June 18, 2009 at 10:05:39
Email: jeff.capron[ ]gmail.com

Message: 67936



Message Reply Form

Use the form below to post a reply to the Re: Re: Re: Cutting Agate with a Chicago Electric Tile Saw? message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.

Your Name: (Required)
E-Mail Address: (Optional)
Subject:Re: Re: Re: Re: Cutting Agate with a Chicago Electric Tile Saw?
Reply Message: (Required)
Last chance to check your message for typos!

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Welcome to Gems By Mail!

Bob Keller