| Message Index | Start New Topic | Photo Gallery | FAQ and Use Tips | Bob's Rock Shop |
Posted in response to Drilling cabs from Richard Brakefield on April 22, 2008 at 17:14:55:
|
drilling would be better prior to shaping,as you must use a diamond drill bit or core drill bit under water(rock and bit under water only!!!) a dremel or foredom with flex shaft a must.i have done this many times and works well,just go slow and at the end of hole go even slower to prevent breakout( chipping) good luck to you.......
From warren kruger - April 24, 2008 at 08:04:26
|
Message Reply Form
Use the form below to post a reply to the Re: Drilling cabs message. If you haven't read the Rock Net FAQ and User Tips yet, now would be a good time to do so.
| Message Index | Start New Topic | Photo Gallery | FAQ and Use Tips | Bob's Rock Shop |
