Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to Respirator needed for wet vibratory flat lap from Dan on August 31, 2008 at 10:53:47:

Re: Respirator needed for wet vibratory flat lap

I have fashioned a cheap plastic bowl to fit into the pan and sits on the rubber ring. I use an elastic cord to hold it down when in motion. This helps to keep the grit and slurry wetter longer. I found without a lid the water would splash out and dry up so I fabricated this up. It will also help in your worry about any air contamination. Adding a cloth over top of the unit will also catch any particals as well. I hope this helps you in some way.

From mike blampied - September 03, 2008 at 08:13:25
Email:

Message: 66951

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop


Bob Keller