Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to Re: Re: Buffing Machine Plans from Bob Keller on August 21, 2008 at 07:58:54:

Re: Re: Re: Buffing Machine Plans

Bob, I would like to help you but I am afraid I can't remember where I got the aluminum disk to back up the felt wheel. It may have been one that came with a Rock Rascal I bought about thirty years ago. I also have another aluminum disk and two others that are 3/4 inch thick plywood wheels bolted by four bolts to five inch pulleys, all of six inches in diameter. I have not had any problems with the plywood wheels, but spinning plywood at those speeds is probably not a practice to be recommended. I have not experimented with different speeds with my unit in the photos I posted, as I seem to get very good results with the present setup.

From jay bates - August 22, 2008 at 08:03:05

Message: 66907

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Bob Keller