Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to How to Salvage Cutting Oil? from John D Gonzales-Lusk on August 19, 2008 at 08:12:26:

Re: How to Salvage Cutting Oil?

I would to take an old bed sheet, fold it a bunch of times and place it over a 5 gallon bucket. Allow it to sag in the center while securing it around the rim and gently pour in the used oil. It may take a bit of time but I think this would filter out a lot of the sludge and particulate. I wouldn't use this method for engine oil, however it should be sufficient for a rock saw.

From Shane - August 20, 2008 at 08:18:17
Email:

Message: 66883

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Bob Keller