Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to Re: Centering sanding disks on flat lap? from jay bates on August 16, 2007 at 21:24:29:

Re: Re: Centering sanding disks on flat lap?

Hi Jay,

No, the disks and plates are the same size, 8". My problem is dropping the disk onto the plate EXACTLY in the center. If I'm off 1/16", the thing spins crooked and walks around like an old washing machine. Having said that, I guess I need to find a way to put exactly a 0.500" exactly round hole exactly in the middle of the paper disk, so that the disk and the plate will line up on the arbor and I can press the two together.

How does everyone do that?

Thanks!

TC

From TC Reg - August 16, 2007 at 23:13:59

Message: 64924

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Bob Keller