Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Posted in response to Centering sanding disks on flat lap? from TC Reg on August 16, 2007 at 11:47:40:

Re: Centering sanding disks on flat lap?

If I read your message correctly the sanding disks are not the same size as the plates. Get out your tape measure and find out the difference and mark half the size difference on the larger of the two on four sides and use the marks to center the other.

From jay bates - August 16, 2007 at 21:24:29

Message: 64923

Message Index Start New Topic Photo Gallery FAQ and Use Tips Bob's Rock Shop

Rock and Mineral Display
Cases, Easels & Stands

Bob Keller